Happy Halloween Disneyland I Stopped By The Fantasia Shop At The Disneyland Hotel The Primary Gift Shop Located In The Fantasy Tower Halloween Is Front And
Halloween Wreaths - Horrible Halloween Art! Do you dare to make some horrible art for Halloween? We dare you! Nothing Cute allowed! UGLY or CREEPY is what we re after here... as in HALLOWEEN! This is creative fun for a family a scout troop a classroom afterschool program. It s a good idea to partner an adult with children 6 and under.. Get all the materials collected about a week ahead of time and do the project a few days before Halloween... paint-drying time is needed as you will see below so you may need three sessions to complete the project. Every wreath will be unique... it s a very creative project. You could make one ahead of time so you have a sample but remind the kids to do their own design. Materials: 3 wire hangers per wreath Newspaper or packing paper Hot glue gun - low temp is OK. Scissors Black and or Orange Spray paint (a kind that holds up outside) Decorations - such as plastic eyeballs rubber bats plastic spiders and some more ugly ugly stuff: fake worms plastic peanuts with googly eyes plastic cockroaches torn up egg cartons. straw... nothing cute allowed! How to do it: Straighten out the hangers.
Leave the string thread long on the legs. Make two legs alike and leave to one side to dry. Skeletons Shoulder Blade Take the main skeleton part with the spoon and ribs and place it face down on the table. Just above the ribs and still leaving the skeleton a neck glue the skeleton s shoulders to the spoon handle. (Tapered ends to the spoon) To support the shoulders make some shoulder blades in the same way as you made the ribs and glue them to the shoulder pieces and over the spoon. Leave to dry. Skeletons Pelvis To make the skeleton s pelvis bone you firstly need to make three ribs. Glue the ribs to the back of the main part just above the end of the spoon handle. Don t leave any gaps between the rib like parts of the pelvis. Leave these parts to dry before continuing. Turn the skeleton over.
Skeletons Arms The skeleton arms have string or wool running through them. With a length of string doubled in half thread the loop through 6 of the discarded peg springs and then thread the rest of the string through the loop and pull tight to that the springs are firmly connected to the end of the string. This is the skeleton s hand. Stick two peg halves back to back with the string sandwiched between. The tapered end of the pegs should point to the hand. This is the forearm. In a similar fashion glue two more peg halves so that the rounded end meets the rounded ends of the forearm. This is the skeleton s upper arm. Finally make the skeletons shoulder with two more pegs the rounded ends meeting the tapered ends of the upper arm. Cut the remaining string at the tapered ends of the skeleton s shoulder. Make two arms in this way. Use some pegs as clamps to hold the pegs until the glue has started to fix the pegs. Leave to one side to dry.