2017 Winter Fest At Carowinds Festival De Invierno 2017 Carowinds 2017 Winter Fest At Carowinds Festival De Invierno 2017 Carowinds
Skeletons Arms The skeleton arms have string or wool running through them. With a length of string doubled in half thread the loop through 6 of the discarded peg springs and then thread the rest of the string through the loop and pull tight to that the springs are firmly connected to the end of the string. This is the skeleton s hand. Stick two peg halves back to back with the string sandwiched between. The tapered end of the pegs should point to the hand. This is the forearm. In a similar fashion glue two more peg halves so that the rounded end meets the rounded ends of the forearm. This is the skeleton s upper arm. Finally make the skeletons shoulder with two more pegs the rounded ends meeting the tapered ends of the upper arm. Cut the remaining string at the tapered ends of the skeleton s shoulder. Make two arms in this way. Use some pegs as clamps to hold the pegs until the glue has started to fix the pegs. Leave to one side to dry.
You might need to use needle-nose pliers to do this. To make a pendant poke an eye pin into the candy corn as described for the earrings. Now the pendant is ready to bake. 5. Bake your candy corn creations according to the package. I baked mine for about 10 minutes at 275F which worked well. 6. (Optional) After the candy corns have cooled you could spray them with acrylic sealer to make them glossy and have a more complete look. This may take a few hours to dry completely. The above suggestions are just a few ideas for how you could use these cute clay candy corns. Take a minute and think of other fun and creative ways you could use these little embellishments. On clothes or on a costume? In a table setting for a party? Maybe on a throw pillow? There are so many possibilities for these little candy corns.
You might want to use pliers. Braid them together and make them into a wreath/circle by twisting the top hooks together. Next tear or cut pieces of paper... about a foot long and wide. Pinch the paper strips in the middle and crunch it up as if you were making a flower. Tuck the "paper flowers" into the little holes in the braided wires and pull tight. Fill up your wreath to fullness! Spray paint it! About three coats of paint is good with about 50 minutes drying time in between. Use the kind of spray paint that holds up outside (in case of rain). Please do the spray painting outside or in a well ventilated room. Cover tables with those inexpensive plastic tablecloths. When the paint is good and dry attach the decorations with the hot (low temp is fine) glue gun. Just be careful not to burn yourself. Adults and older kids should be the glue gunners. You are done! Hang it up on your front door maybe with an orange light aimed at it.