Halloween Immagini Halloween Hd Wallpaper And Background Foto 35969902 Halloween Wallpaper Entitled Halloween
With the white on top make angled cuts through the clay. You are trying to make triangular shaped pieces with the white being at the small tip and the yellow at the wider bottom. 3. Now to give them a more finished look smooth and round the edges. Now the candy corn is finished. Before you bake them decide if you are going to leave them as plain candy corn or if you would like to turn them into buttons earrings or maybe a necklace pendant. 4. To make buttons just poke two holes in the middle of the orange clay. Now the buttons are ready to bake. To make earrings you will need eye pins and earring hooks. Poke the eye pins straight down from the top of the candy corn. Then press the clay around the pin so it will hold. Now the earrings are ready to bake. To finish your earrings attach the earring hooks.
You might need to use needle-nose pliers to do this. To make a pendant poke an eye pin into the candy corn as described for the earrings. Now the pendant is ready to bake. 5. Bake your candy corn creations according to the package. I baked mine for about 10 minutes at 275F which worked well. 6. (Optional) After the candy corns have cooled you could spray them with acrylic sealer to make them glossy and have a more complete look. This may take a few hours to dry completely. The above suggestions are just a few ideas for how you could use these cute clay candy corns. Take a minute and think of other fun and creative ways you could use these little embellishments. On clothes or on a costume? In a table setting for a party? Maybe on a throw pillow? There are so many possibilities for these little candy corns.
Skeletons Arms The skeleton arms have string or wool running through them. With a length of string doubled in half thread the loop through 6 of the discarded peg springs and then thread the rest of the string through the loop and pull tight to that the springs are firmly connected to the end of the string. This is the skeleton s hand. Stick two peg halves back to back with the string sandwiched between. The tapered end of the pegs should point to the hand. This is the forearm. In a similar fashion glue two more peg halves so that the rounded end meets the rounded ends of the forearm. This is the skeleton s upper arm. Finally make the skeletons shoulder with two more pegs the rounded ends meeting the tapered ends of the upper arm. Cut the remaining string at the tapered ends of the skeleton s shoulder. Make two arms in this way. Use some pegs as clamps to hold the pegs until the glue has started to fix the pegs. Leave to one side to dry.