Free Printable Halloween Contest Certificates Halloween Printables Worksheets Activities Teachervision Fill In Halloween Story A Scary Night
Leave the string thread long on the legs. Make two legs alike and leave to one side to dry. Skeletons Shoulder Blade Take the main skeleton part with the spoon and ribs and place it face down on the table. Just above the ribs and still leaving the skeleton a neck glue the skeleton s shoulders to the spoon handle. (Tapered ends to the spoon) To support the shoulders make some shoulder blades in the same way as you made the ribs and glue them to the shoulder pieces and over the spoon. Leave to dry. Skeletons Pelvis To make the skeleton s pelvis bone you firstly need to make three ribs. Glue the ribs to the back of the main part just above the end of the spoon handle. Don t leave any gaps between the rib like parts of the pelvis. Leave these parts to dry before continuing. Turn the skeleton over.
You might want to use pliers. Braid them together and make them into a wreath/circle by twisting the top hooks together. Next tear or cut pieces of paper... about a foot long and wide. Pinch the paper strips in the middle and crunch it up as if you were making a flower. Tuck the "paper flowers" into the little holes in the braided wires and pull tight. Fill up your wreath to fullness! Spray paint it! About three coats of paint is good with about 50 minutes drying time in between. Use the kind of spray paint that holds up outside (in case of rain). Please do the spray painting outside or in a well ventilated room. Cover tables with those inexpensive plastic tablecloths. When the paint is good and dry attach the decorations with the hot (low temp is fine) glue gun. Just be careful not to burn yourself. Adults and older kids should be the glue gunners. You are done! Hang it up on your front door maybe with an orange light aimed at it.
Skeletons Legs The skeleton legs like the arms have string running through them. As before double the string up and wrap around a peg half so that the string slots into the groove that the spring grabbing bit of metal once was. Make a loop and feed the remaining string through the loop so that the peg half is attached to the end of the string (shaped side up). This is the skeleton s foot. Make the shin like the forearm with two peg halves the tapered end pointing towards the foot. The thigh starts off in the same way as the upper arm with two peg halves sandwiching the string and the rounded part meeting the rounded part of the shin. On top of this two more peg halves are attached. Join these peg halves with their rounded ends glued to the tapering pegs of the upper arm like pegs and stick their tapered tip together with the string sandwiched between.