Halloween Email Templates Free Halloween Email Templates Outlook Halloween Email Templates Halloween Email Invite Templates Halloween Email Templates Outlook
Make lots of these along the pathway and it would look really scary. Idea #3 - You will require orange construction paper white construction paper pencil scissors string tape glue and staples. Draw a picture of a ghost on the white chart paper and pumpkin faces on the orange one. Be sure to make it a free hand draw to get originality. Also leave some space on top of the chart so that you can hang it to make a garland of ghosts and pumpkin faces. Fold over the space and place the string by the fold. Secure the created articles using staples glue and tape. The pumpkin garland would look good with a green string and the ghosts with a black string to have a good contrast. Hang them all round your house and start the party. Apart from these ideas tons of examples and ideas can be found on the World Wide Web but the best information center is your brain.
Table sprinkles in the form of ghosts pumpkins witches or bats can be used to give that creepy look. Place these decorated candles around the house and watch them light up the evening! Another art and craft Halloween decoration is the creepy balloon ghost which is very easy to make. All you need is white balloons and plastic grocery bags. The bags should be plain with no writing on them. Here is how to create a spooky ghost: Cut off the handles of the grocery bag. Leaving the bottom of the bag intact with the help of scissors cut the bag into dangling strips up to about an inch from the bottom seam. In the same manner cut up another grocery bag. Fill up the balloon with air and knot it up. Tape the seam of one bag to the front and the other to the back leaving the knot on top.
Skeletons Arms The skeleton arms have string or wool running through them. With a length of string doubled in half thread the loop through 6 of the discarded peg springs and then thread the rest of the string through the loop and pull tight to that the springs are firmly connected to the end of the string. This is the skeleton s hand. Stick two peg halves back to back with the string sandwiched between. The tapered end of the pegs should point to the hand. This is the forearm. In a similar fashion glue two more peg halves so that the rounded end meets the rounded ends of the forearm. This is the skeleton s upper arm. Finally make the skeletons shoulder with two more pegs the rounded ends meeting the tapered ends of the upper arm. Cut the remaining string at the tapered ends of the skeleton s shoulder. Make two arms in this way. Use some pegs as clamps to hold the pegs until the glue has started to fix the pegs. Leave to one side to dry.