Halloween Candy Bar Wrappers Template Halloween Candy Bar Wrappers Printables
Then use a witch s hat for the covered scarecrow head. Punch a hole in the hat where the hook of the hanger can go through. Hang the body over windows doors or cabinet handles. For cobwebs you can use cottons which you can spread all over the place. Cotton cobwebs is great for any theme you may have in mind. You can also use washable paint on your windows-you can either use spooking green all over or apply splashes of red for "blood". Replace your white bulbs with black orange or red ones bulbs for an eerie lighting effect. You can also cover lamps with colored cloth or netting for eerie shadows. Halloween is a time when one can experiment with creative craft ideas to make wonderful decorations for the house. It is an opportunity to dabble in the wonderful world of art and craft.
Skeletons Arms The skeleton arms have string or wool running through them. With a length of string doubled in half thread the loop through 6 of the discarded peg springs and then thread the rest of the string through the loop and pull tight to that the springs are firmly connected to the end of the string. This is the skeleton s hand. Stick two peg halves back to back with the string sandwiched between. The tapered end of the pegs should point to the hand. This is the forearm. In a similar fashion glue two more peg halves so that the rounded end meets the rounded ends of the forearm. This is the skeleton s upper arm. Finally make the skeletons shoulder with two more pegs the rounded ends meeting the tapered ends of the upper arm. Cut the remaining string at the tapered ends of the skeleton s shoulder. Make two arms in this way. Use some pegs as clamps to hold the pegs until the glue has started to fix the pegs. Leave to one side to dry.
Skeletons Legs The skeleton legs like the arms have string running through them. As before double the string up and wrap around a peg half so that the string slots into the groove that the spring grabbing bit of metal once was. Make a loop and feed the remaining string through the loop so that the peg half is attached to the end of the string (shaped side up). This is the skeleton s foot. Make the shin like the forearm with two peg halves the tapered end pointing towards the foot. The thigh starts off in the same way as the upper arm with two peg halves sandwiching the string and the rounded part meeting the rounded part of the shin. On top of this two more peg halves are attached. Join these peg halves with their rounded ends glued to the tapering pegs of the upper arm like pegs and stick their tapered tip together with the string sandwiched between.