Skeletons Legs The skeleton legs like the arms have string running through them. As before double the string up and wrap around a peg half so that the string slots into the groove that the spring grabbing bit of metal once was. Make a loop and feed the remaining string through the loop so that the peg half is attached to the end of the string (shaped side up). This is the skeleton s foot. Make the shin like the forearm with two peg halves the tapered end pointing towards the foot. The thigh starts off in the same way as the upper arm with two peg halves sandwiching the string and the rounded part meeting the rounded part of the shin. On top of this two more peg halves are attached. Join these peg halves with their rounded ends glued to the tapering pegs of the upper arm like pegs and stick their tapered tip together with the string sandwiched between.
Make a number of such luminaries and line your walkway with them for the trick or treat night. Another arts and craft idea for Halloween is to drape your home with fun ghost or pumpkin garlands. These garlands are really easy to make. You require some white construction paper if you are making ghosts or orange construction paper if you are making pumpkins. Draw your ghost or pumpkin on the paper using a pencil or pen. Ensure that while drawing the figures you leave a tab on the top to fold while stringing the garland. Draw funny or scary faces on the figure using a black marker and then cut out the figures. To make your garland really long cut out many such figures. Place the string on the fold of the tab. Use staples glue or tape to secure the figures.
As said creativity is the master of all arts. Making candy corn out of polymer clay is quite easy and it is an excellent project for just about any age group. These little polymer clay candy corns are so cute and are great for adding to all sorts of decorations and other things. You could use them to embellish things like frames magnets candles or even for adding to scrapbooking pages. Supply List: - Polymer clay (yellow orange white) - I normally use the Sculpey brand Clear acrylic sealer (optional) Instructions: 1. Warm up each color of clay by rolling and kneading it until it feels soft. Now roll each color out until it s about 1/4" thick. Now press the three rolls together with white on top orange in the middle and yellow on the bottom. 2. Find a thin sharp edge such as a thin piece of cardboard to use to slice through the clay.